BMW/PC-KNNSR INSTALLATION INSTRUCTIONS

INSTALLATION INSTRUCTIONS FOR THE BMW/PC-KNNSR

Always check the P.I.E. DPX Protocol Converter Application Guide before installation to ensure you have selected the correct P.I.E. part for your specific vehicle.

CAUTION: Before any connections are made, P.I.E. strongly recommends that all circuits be verified with a voltmeter before interfacing with them. Always set the parking brake before working on any vehicle.

DO NOT force connectors together as pin damage may occur. This installation will be flawless if you take your time making the connections described below. Following the installation sequence below is critical to ensure proper recognition of the CD changer by the factory radio.

The BMW/PC-KNNSR can be used in the following applications: CD-Changer OR Music Keg interface, Sirius-Tuner interface, Sirius-tuner and Music-Keg, CD-Changer and Sirius-Tuner interface

INSTALLATION:

NOTE: BMW radios are code protected. Verify that the code is available before disconnecting the battery.

1. Disconnect the negative battery terminal.
2. Locate the factory data cable (3-pin and 6-pin).
3. Plug the factory data cable into the 3-pin and 6-pin sockets of the BMW/PC-KNNSR. When used as a CD-Changer (OR) Music-Keg interface: (see diagram)
4. Plug one end of the Kenwood data cable (supplied with Kenwood device) into the female 13-pin DIN of the BMW/PC-KNNSR.
5. Route the Kenwood data cable to the Kenwood device location, being careful NOT to pinch or damage the cable.
6. Plug the Kenwood data cable into the mating connector of the Kenwood device. (see diagram). When used as a CD-Changer and Sirius-Tuner interface: (see diagram)
7. Plug one end of the Kenwood data cable (supplied with Kenwood Sirius-tuner) into the female 13-pin DIN of the BMW/PC-KNNSR.
8. Route the Kenwood data cable to the Sirius-tuner, being careful NOT to damage the cable, and connect to the "To Head Unit" plug.
9. Connect the Changer data cable (supplied with changer) to the "To Changer" plug of the Sirius tuner and route to changer location. When used as a Sirius-Tuner and Music-Keg interface: (see diagram on back)

10. Plug one end of the Kenwood data cable (supplied with Kenwood Sirius-tuner) into the female 13-pin DIN of the BMW/PC-KNNSR.
11. Route the Kenwood data cable to the Sirius-tuner and connect to the "To Head Unit" plug, being careful NOT to damage the cable.
12. Connect the M-Keg data cable (supplied with M-Keg) to the "TO Changer" plug of the Sirius tuner and route/connect to Music-Keg location.
13. Reconnect vehicle's negative battery terminal.

VERIFY OPERATION:

1. Load CD's into the CD changer cartridge and insert the cartridge into the changer.
2. Press CD or Mode button to access CD changer mode.
3. Only when used as a Sirius/CD-Changer interface, use the "RANDOM" feature to toggle between Sirius and CD-Changer modes.

back to BMW Traffic Pro home page

Esmerelda's Home Page~ Z3ers.com